I can't control the device when connected with Wi-Fi (wireless).
Device screen control might not be available on devices that are not directly supported by Mobizen (Android 5.0 or lower, Nexus, Sony, Motorola, Xiaomi, Huawei) due to lack of control permission.
To help to solve this issue, Booster mode can be enabled to obtain the permission and allow screen control.
Download the Mobizen Mirroing Application and connect the device using USB to enable the Booster mode.
[Booster Mode pre-requirements]
No. | Requirement | What do to |
1 | USB Debugging | Settings > Developer Option > USB Debugging |
2 | Install Mobizen PC application | Download |
3 | Connect between PC and Mobile device | Connect using USB cable |
4 | USB driver installation | Run Mobizen PC application to install the unified driver |
5 | Allow USB debugging (using RSA key from the PC) |
Check Box then accept the USB debugging of the PC |
Please follow the instructions below in the set order.
Enabling USB debugging mode
you need to gain developer authority with your Android.

3. Connect PC and mobile device via USB and install the driver
– Connect the mobile device to your computer using the USB cable.
(Go to Step. 5, if USB driver and Mobizen application had already been installed, USB debugging allowance will then pop up and ask for your permission.)
– You must run Mobizen after connecting the mobile device to your PC using a USB cable. A unified USB driver will be installed, as shown in the pictures below.

4. Allow the USB debugging

5. Booster Mode has started!
*If your device has rebooted, keep your mobile device connected to your computer (Mobizen PC application installed) using the USB cable until the booster mode activation message displayed

Comments 0